<noscript id="gwli0"></noscript>

    <sub id="gwli0"><listing id="gwli0"><small id="gwli0"></small></listing></sub>
    1. <nav id="gwli0"><code id="gwli0"></code></nav>
      Products
       Home > NewsNews

      The relationship between the pulley rope groove and the wire rope

      View: 120005/23/2017  

      The relationship between the pulley rope groove and the wire rope


      The depth of groove should be selected so that the rope does not rub against the flange of the sheave or each other while entering running or leaving the groove. Angle of circular arc of the bottom of groove should not be less than 120 Degrees.

      The grooves on the drum should be pitched so that there is clearance between neighboring turns of rope on that drum. The recommended clearances are 1.5 mm up to rope diameter of 28 mm and 3 mm for rope diameter above 28 mm.

      The groove diameter of the pulley or sheave should always be larger then actual diameter of the rope. But if the groove diameter is too large the rope will tend to flatten and if it is too small pinching or rope will take place. The correct positioning is explained as under along with the tolerance and clearances on pully or sheave groove diameters.

      Related products
      Hot Rolling sheave
      Hot Rolling sheave
      Full forging sheave/solid sheave
      Full forging sheave/solid sheave
      Ring forging sheave
      Ring forging sheave
      Ring forging
      Ring forging
      View More(Total0)Comment Lists
      No Comment
      I want to comment
      Content *
      Verification Code*
      中文
      Hrvatska
      Fran?ais
      Italiano
      Português
      日本の
      ???
      ???????
      Deutsch
      ?esky
      Dansk
      Nederlands
      suomi
      Ελληνικ?
      ??????
      norsk
      Türkiye
      ?????????
      български
      русский
      Svenska
      Polski
      Roman?
      Vi?t Nam
      ewm
      亚洲高清aⅴ日本欧美视频